Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Pembroke Pines?
Spring replacement in Pembroke Pines typically costs $180 – $340 for a single spring, and most doors here run two, so a matched pair usually lands around $360 – $680. The written estimate we give you after looking at the door sets the final price. That range covers the springs, the labor, and balancing the door afterward, which is the part most homeowners don’t think about until the door slams or reverses on its own.
A torsion spring on a double door and a pair of extension springs on a lighter single door are different jobs, and the price difference between the low and high end of that range is usually about which system you have. Call (844) 443-4021 if you want a real number for your door instead of a range.
Key Takeaways
- A single spring is typically $180 – $340; a matched pair is about double, so $360 – $680.
- Springs usually fail in pairs. If one has snapped, the other is close behind it, and replacing both once is cheaper than two separate visits.
- Price depends on spring type, door weight, and whether cables, rollers, or the center bearing also need attention.
- Estimates are free, so you can find out what your door actually needs before you commit.
- Our technicians have up to 13 years of experience with springs, openers, and full door systems.
Spring Replacement Cost Breakdown (2026)
Here’s how spring work breaks down by line item in Pembroke Pines. These are typical estimated ranges for 2026, not fixed quotes.
| Item | Typical Estimated Cost |
|---|---|
| Single spring replacement (torsion or extension) | $180 – $340 |
| Matched pair of springs | $360 – $680 |
| Cable repair (often done with springs) | $130 – $250 |
| Track realignment if the door twisted on failure | $120 – $240 |
| Roller replacement while the door is apart | $110 – $220 |
| Panel replacement if a spring let go and the door dropped hard | $250 – $500 |
| Opener repair if the motor was strained by a dead spring | $120 – $320 |
| Full garage door repair (combined issues) | $150 – $600 |
What pushes the number up: a matched pair instead of a single spring, a heavy double door, asecond story or limited clearance above the door, and any collateral damage the failure caused. What keeps it near the low end: a standard single door with clear access, no cable damage, and a spring swap that’s the only thing on the list. If your door dropped and bent something on the way down, expect the total to climb, because the spring is no longer the only repair.
What Affects Spring Replacement Pricing in Pembroke Pines
Pembroke Pines is built on mostly single-family and townhome construction with a lot of two-car garages, and that shapes what we see here. Here are the factors that move the price:
- Spring type. Torsion springs sit on a shaft above the door and extension springs run along the sides. The two use different tools, mounts, and tension settings, so a swap for one system isn’t priced like the other. Extension spring pairs are usually on the lower end; torsion pairs take longer to balance correctly.
- Door weight and size. A standard single door needs lighter springs than a double door with insulated panels. Heavier doors mean longer cycle-rated springs and more careful tensioning, which adds to the labor side of the estimate.
- Whether one spring or two. A single spring will usually cost less than a pair. Matching both springs at once is the common approach on torsion systems so the door stays level.
- Cable and drum condition. In South Florida, doors that have been through years of summer heat and humidity often have frayed cables and worn drums by the time a spring goes. We check those before we quote, because putting new springs on frayed cables is a liability.
- Opener strain. A door with a dead spring gets dragged up by the motor. That’s hard on the opener’s gears and board, and it’s not unusual for a spring job to turn into an opener repair once we look at it. If you’ve been running the door with a broken spring, tell us when you call.
- How easy the door is to reach. Low-clearance setups, a car parked under the door, or a panel that’s been bent out of alignment all add time. Access is the quiet cost factor.
How to Save on Spring Replacement
You can’t safely do springs yourself, but you can keep the bill near the bottom of the range. Here’s what actually helps:
- Replace the pair together. One spring today and the other in six months means two service calls, two visits, and twice the chance something else falls apart in between. Matching both now usually costs less overall than two single-spring jobs.
- Fix cables and rollers while the door is open. If the door is already apart for springs, swapping frayed cables or worn rollers at that point saves the second visit later. Our garage door repair Pembroke Pines Pros team can bundle those on the same visit.
- Stop using the door once a spring breaks. Running a broken spring burns out the opener, and an opener repair on top of the springs eats the savings. Leave the door down until a technician gets there.
- Get the estimate before the work. We give free estimates with the price up front, so there are no surprises when the job is done. Call (844) 443-4021 for a number on your door.
- Ask about cycle rating. Standard springs and high-cycle springs cost different amounts and last different lengths of time. Tell us how often the door runs and we’ll match the spring to that.
How Dangerous Is Spring Replacement?
Torsion and extension springs hold enormous stored tension, and a spring under load can cause a serious injury if it’s handled wrong. That’s why we don’t give DIY steps for this job and don’t recommend anyone try it. A trained technician uses proper winding bars, a door lock, and controlled tension release. On a torsion system, the winding process is the riskiest part of the whole trade. This is the one garage door repair where we’d rather you stop and call than watch a video. We handle spring replacement carefully because it’s the part of the job most likely to go wrong.
Repair or Replace: When Springs Are the Only Fix
If the springs are the only problem, repair is clearly the way to go. The door itself can outlast many sets of springs. Where it gets less obvious is an older door with a broken spring, rusted sections, and a tired opener all at once. In that case, a full new door installation at $700 – $2200 can make more sense than piecemeal repairs over months. We’ll tell you honestly which side of that line your door is on. Repair-first is the default when the panels and frame are sound.
Do Springs Break More Often in the Pembroke Pines Climate?
Heat doesn’t snap a spring on the spot, but it does work on them over time. Pembroke Pines summers are long, humid, and hot, and a garage that faces the afternoon sun gets genuinely hot inside. Heat cycling and humidity age the steel, the grease on the torsion shaft, and the cables faster than in a milder climate. Doors that get used several times a day on top of that will see springs fail sooner than the same door up north. That’s why we look at the whole system, not just the broken spring, when we quote a replacement.
Ground settling matters here too. Central Pembroke Pines and the western neighborhoods sit on soil that shifts with the wet season, and after enough rainy summers a door can drop slightly out of level. An out-of-level door puts more strain on one spring than the other, and that uneven load wears the springs faster. If your door looks crooked when it’s down, mention it when you call, because we may need to realign the garage door as part of the job.
What Does Spring Replacement Usually Involve?
A typical visit starts with a full look at the door: spring type, cable condition, drum wear, track alignment, and how the opener has been handling the load. Then the technician measures for the right spring, releases the old tension, swaps in the new spring or pair, and winds the new system to the correct tension. After that, the door gets balanced and cycled to check it runs evenly. The whole job is usually a single visit when the parts are the standard sizes, and if it needs a nonstandard spring you’ll hear about the lead time before we start.
We service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems, so we’re not guessing at the door’s geometry or the opener’s settings when we put it back together. That matters most when a spring job turns into an opener reset or a full installation, which our team handles through the entire life of the door. If it’s urgent and the door is stuck open or half down, ask about emergency garage door service when you call.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Pembroke Pines?
Typical estimated cost is $180 – $340 for one spring and about $360 – $680 for a matched pair, and the written estimate sets the final price. Heavy double doors, cable damage, or opener strain can push the total up. Call (844) 443-4021 for a free estimate.
Is it cheaper to replace one spring or both?
Replacing both at once usually costs less overall than two separate single-spring visits, because a matched pair is roughly double one spring’s price but avoids a second service call. The two springs on a torsion system wear at the same rate, so the second one typically follows the first within months. Call (844) 443-4021 and we’ll quote the pair.
Can you fix a broken spring the same day?
Same-day service is often possible when the spring matches standard sizes, and we’ll tell you at the time of the call what the schedule looks like. Emergency spring failures get priority because a door stuck open leaves the house exposed. Call (844) 443-4021 to check availability.
Why is my spring replacement quote higher than the range on this page?
Quotes above $680 usually mean extra work: bent tracks, frayed cables, a strained opener, or a door that dropped and damaged a panel. Each of those is priced separately, and we list them out before starting. The written estimate sets the final price, so ask for the itemized breakdown. Call (844) 443-4021 for yours.
Do you replace springs on my brand of door?
Yes. We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems, so the spring and hardware we fit are correct for your specific door. Call (844) 443-4021 and tell us the brand.
Spring replacement is a small job with an outsized risk when it’s done wrong, and the price reflects the training and tools it takes to do it safely. If the door is down or won’t stay up, don’t wait. Call (844) 443-4021 for a free estimate, and we’ll get a technician out to look at the springs and any related parts, including your opener and cables. Our technicians have up to 13 years of experience, and the estimate is free.
Written by the team at Garage Door Repair Pembroke Pines Pros.
Pricing reflects the Pembroke Pines market as of 2026. Garage Door Repair Pembroke Pines Pros offers free estimates – call (844) 443-4021.
Note on internal links: You asked for ~12 in-content links, but only 3 URLs were supplied (the pillar ``, the spring replacement page, and a garage door repair city page referenced as existing). I linked only those three and did not invent any URLs, since linking to pages that don’t exist is blocked by the brief. If you can supply the remaining city and guide URLs, I can add the rest. Also, the final byline uses an em dash in the required boilerplate text; tell me if you want that replaced with a hyphen or colon.
What Our Customers Say
"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Kevin Fletcher"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
- Imani Ingram"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Vikram Rao